Accord V6 Powersteering Belt — HONDA
Accord V6 Powersteering Belt on Honda: 11 steps, engines J30A1. What to remove, in what order, and what to check after.
Workshop procedure for HONDA — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 3.0, V6
🔧 Engine codes this applies to
📋 Procedure
- Power steering pump:
- Refit the drive belt
- Tighten the ancillary drive belt tensioner
- Tension the belt
- The tension is set at a deflection of:
- New belt:
- Used belt:
Other HONDA procedures
- Honda Accord 2.0 K20A6/K20Z2 timing chain replacement
- Honda Accord 2.4 K24A3 timing chain replacement
- Honda Stream 2.0 K20A1 timing chain replacement
- Honda FRV 2.0 K20A9 timing chain replacement
- Honda CRV engines 2002> timing chain replacement
- Accord CG_CH 2.0 16V F20B timing belt
- Honda Civic FN, FK 2.0 K20Z4 timing chain replacement
- Honda Civic FN, FK N22A timing chain replacement
- Honda Civic FN, FK L13A, L13Z 1.3 timing chain replacement
- Honda Civic EM, EP, ES, EU, EV 2.0 timing chain replacement
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.