Vehicles with 4-cylinder unit injector TDI engine — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Secure brake disc with wheel bolt.

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery (see the separate procedure). [Note: Secure brake disc with wheel bolt.]
2. Release fasteners (1, 2) and (arrow) (if fitted) to remove noise insulation.
3. Unbolt heat shield (1) for drive shaft (right-side).
4. Remove bolts (1) and (2).
5. Detach starter and swivel aside.

6. Unplug electrical connector (3).
7. Unscrew nut (1) for clamp.
8. Unscrew nut (2) and remove electrical wiring.
9. Take out starter.
10. Connect battery. Steps required (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing cylinder head - engine codes AEB, AJL – Audi 1.8
• Removing cylinder head - engine codes ANB, APU, ARK, ATW
• Installing sump - engines with liquid gasket – Audi A4 B5 1.8 · 1 torque figures
• Installing sump (bottom section) - engines with moulded gasket · 2 torque figures
• Checking intake manifold pressure sender G71 – Audi A8 D2