Vehicles with 1.8 ltr. turbo and 2.0 ltr. MPI engine — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. On vehicles with auxiliary heater, unscrew bolts (arrows) for exhaust pipe of auxiliary/supplementary heater at noise insulation.
3. Unfasten bolts/quick-release fasteners (1) and (2) and detach noise insulation (front).
4. Unscrew wire for terminal B+ (item 2).
5. Unplug electrical connector for terminal 50 (item 1).

6. If fitted, detach insulator at positive connection for starter.
7. Unscrew clamp (4).
8. Unscrew bracket for starter at cylinder block (3) and starter.
9. Remove bolts (1) and (2).
10. Guide starter downwards and remove.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing oil seal for flange shaft / front propshaft (transfer box installed)
• Checking delivery pressure of power steering pump (vehicles with 10-cylinder petrol engine)
• Removing and installing engine compartment cross member - R8 Spyder with manual gearbox/R tronic gearbox 086
• Removing and installing coolant pipes located at centre of vehicle
• Removing and installing mounting bracket for clutch pedal and clutch master cylinder