TT_3.2V6_BHE/BPF Engine removal — AUDI

🧭 Before you start

Fits: platform codes 3.2, V6

• Opens: coolant

Don't miss

• Do not disconnect the wiring
• Caution! Do not damage the flexible pipe

🔧 Engine codes this applies to

📋 Procedure

1. Disconnect the battery earth cable
2. Use new bolts
3. Remove both front wheels
4. Stage 2:
5. Drain the coolant from the engine block and radiator

6. Disconnect all the cables, hoses and lines from the engine and gearbox
7. Stage 1:
8. Remove the fuse box from the mounting bracket
9. Note: Do not disconnect the wiring
10. Use new bolts
11. Exhaust pipe to catalytic converter:
12. Disconnect the control unit with the wiring and place it on the engine
13. Remove the ancillary drive belt
14. M6:
15. M8:
16. Left-hand engine mount:
17. Loosen the bolts
18. Stage 1:
19. Stage 2:
20. Vehicles with semi-automatic transmission
21. Loosen the bolts
22. Remove the cross member
23. Disconnect the reversing light switch
24. Remove the power steering pulley
25. Disconnect the power steering pump lines
26. Remove the power steering pump
27. Remove the secondary air pump motor and bracket if fitted
28. Remove the radiator assembly
29. Without disconnecting the hoses, place the air-conditioning compressor aside
30. Remove the alternator
31. Disconnect the front exhaust flexible pipe
32. Caution! Do not damage the flexible pipe
33. Remove both front drive shafts
34. Disconnect the propeller shaft from the transfer box
35. Remove the pendulum support
36. Disconnect the oil level sensor
37. Remove the ancillary drive belt bracket
38. Fit the special tool to support the engine
39. Remove the engine/gearbox

Other AUDI procedures

• Removing and installing electrical radiator fan V7 and radiator fan -2-V177
• Checking injection quantity and spray pattern of injectors; checking for leaks · 1 torque figures
• Adjusting accelerator position sender G79 - right-hand drive vehicles without accelerator pedal module
• Checking activated charcoal filter solenoid valve 2N115
• Checking fuel system diagnostic pump V144 – Audi TT Mk1 1.8
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures