Selecting control unit for automatic gearbox — AUDI

🧭 Before you start

Fits: platform code 70A

• Also covered elsewhere: Fault table, page under fault code"“65535”" Control unit defective! Press → key

📋 Procedure

1. Switch on ignition.
2. Switch on printer with the Print key (indicator lamp in key lights up).
3. Press key 1 for "“Rapid data transfer”" mode.
4. Press keys 0 and 2. (02 enters address word "“Gearbox electronics”".)
5. Confirm entry with Q key.

6. By pressing the HELP key, a list of possible fault causes is printed out.
7. After eliminating the possible causes of faults, again enter the address word 02 for "“gearbox electronics”" and confirm.
8. Perform test step 1 , Electrical test.
9. Check wiring connections to diagnostic sockets
10. ⇒ Fault table, page under fault code"“65535”" Control unit defective!
11. Press → key.
12. After the HELP key is pressed, a list of the possible functions is printed out.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing cylinder head, ABH, AEC
• Removing and installing cover with Torsen differential
• Connecting fault reader V.A.G 1551 and selecting address word
• Dismantling and assembling air distributor housing
• Servicing refrigerant circuit in vehicles with compressor with regulating valve -N280