Renewing seal for crankshaft poly V-belt pulley end: Audi 1.4 (BCA, BUD)

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015)

🔧 Engine codes this applies to

📐 57 workshop diagrams for BCA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove front right wheel housing liner General body repairs66Removing and installing wheel housing liner; Front wheel housing liner.
2. Remove noise insulation 50.
3. Remove poly V-belt .
4. Then remove main drive toothed belt .
5. Then remove crankshaft toothed belt pulley.

6. To guide oil seal extractor3240, screw crankshaft toothed belt pulley securing bolt into crankshaft to stop.
7. Screw inner part of oil seal extractor3240 three turns (approx. 5 mm) out of outer part and lock using knurled screw.
8. Lubricate threaded head of oil seal extractor, place it in position and while exerting firm pressure screw it into oil seal as far as possible.
9. Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.
10. Lightly oil sealing lip of oil seal.
11. Fit assembly tool T10022 onto crankshaft journal and turn spindle T10022/2 in to stop.
12. Slide oil seal over assembly tool T10022.
13. Press in oil seal to stop with press piece T10022/1.
14. Install main drive toothed belt .

Other AUDI procedures

• Assembly overview - exhaust manifold with catalytic converter and add-on parts
• Removing and installing natural gas tanks 1 and 2
• Removing and installing natural gas tank 5, Caddy Maxi
• F - Re-pressing sender wheel · 11 torque figures
• Skoda New Octavia 1.4 BCA/BUD timing belt replacement
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures