Renewing right oil seal — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

• Special tools named: puller
• Renewed: sleeve

Don't miss

• Remove flange shaft securing bolts. Screw 2 bolts into flange and counterhold flange shaft using a lever.
• Do not damage sleeve. Otherwise, leaks will occur.Replace sleeve if damaged .

📋 Procedure

1. Remove any noise insulation General body repairs, exterior66Noise insulation.
2. Turn steering to right to full lock.
3. Remove drive shaft shield from engine, if fitted.
4. Disconnect drive shaft (1) from flange shaft.
5. Raise drive shaft as high as possible and secure. Take care not to damage paint on drive shaft in the process.

6. Place drip trayV.A.G 1306 under gearbox and engine.
7. If necessary, unbolt oil return line for turbocharger from engine (arrow)Power unit21Assembly overview - turbocharger.
8. Remove flange shaft securing bolts. Screw 2 bolts into flange and counterhold flange shaft using a lever.
9. Pull out flange shaft with compression spring.
10. Lever out seal using a screwdriver (A). Support screwdriver on assembly tool3253/2 when doing this. [Note: Do not damage sleeve. Otherwise, leaks will occur.Replace sleeve if damaged .]
11. Pull out seal and sleeve together.
12. Place puller hooksVW 771/37 directly behind shoulder in sleeve.
13. Press extractor hooksVW 771/37 forcefully into sleeve while pulling.
14. Drive in new seal to stop, being careful not to cant seal.
15. Fill space between dust lip and sealing lip half full with sealing greaseElectronic Parts Catalogue.
16. Insert flange shaft.
17. Clean seat for seal in gearbox.
18. Pull in seal and sleeve together.
19. Pull in seal with sleeve to stop using thrust piece T10148 by turning nut (B).
20. Fill space between dust lip and sealing lip half full with sealing greaseElectronic Parts Catalogue.
21. Insert flange shaft.
22. Secure flange shaft with countersunk bolt.
23. If turbocharger oil return line has been removed from engine, install it now (arrow)Power unit21Assembly overview - turbocharger.
24. Bolt drive shaft (1) to flange shaft Running gear, axles, steering40Drive shafts.
25. Install drive shaft shield if necessary.
26. Check gear oil .
27. Install any noise insulation General body repairs, exterior66Noise insulation.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Overview of fitting locations - parking brake
• Exploded view - single-plate clutch (LuK version)
• Removing and installing engine speed sender G28
• Checking backrest locking switch unit (microswitches)
• Removing and installing heater controls with heater control unit J65