Renewing connecting pipe for washer jet: Audi A4 B5

🧭 Before you start

Fits: Audi A4 B5 (8D)

• Renewed: drive shaft, seal

📋 Procedure

1. Remove washer jet .
2. Remove wiper arm .
3. Remove trim at bottom of rear lid 70.
4. Disconnect washer fluid hose (1) from connecting pipe (3) for washer jet.
5. Unscrew bolts (arrows) and detach cover (2).

6. Renew drive shaft.
7. Working from inside, insert connecting pipe (2) in cover (1).
8. Fit new seal on rear window wiper motor.
9. Carefully insert connecting pipe in drive shaft and secure cover.
10. Press washer fluid hose onto connecting pipe for washer jet.
11. Install trim at bottom of rear lid 70.
12. Adjust wiper arm .
13. Insert washer jet with new O-ring (3) in connecting pipe.
14. Adjust washer jet.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures