Renewing clip on sensor for adaptive cruise control G550 — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

📋 Procedure

1. Remove sensor for adaptive cruise control .
2. Release catches (arrows).
3. Pull cover (A) off sensor for adaptive cruise control (B).
4. Remove stud (1) using a suitable tool (2).
5. Insert a screwdriver between hook and housing.

6. Using the screwdriver, bend each hook outwards towards the centre until it audibly breaks off.
7. To avoid broken hooks becoming caught in housing, remove hooks from inside clip with long-nose pliers.
8. Insert new clip into bore in housing from left and press on by hand until it engages audibly.
9. Insert stud.
10. Screw stud into adaptive cruise control unit as far as dimension (a).
11. Repeat procedure for other clips if necessary.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing intact side window – Audi A6 C5
• Checking fuel system for leaks - vehicles with 2.5 ltr. 6-cylinder engine
• Checking fuel pump control unit J538 - vehicles with 4-cylinder TFSI engine
• Belt buckle anchorage point · 1 torque figures
• Removing and installing lateral acceleration sender – Audi · 1 torque figures