Removing rack for variable convertible roof compartment: Audi A4 Cabriolet B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

📋 Procedure

1. Remove variable convertible roof compartment .
2. Pull off floor covering (1) (convertible roof compartment lining) on relevant side to such an extent that the two bolts (2) can be accessed.
3. Remove bolts (2) (2x).
4. Separate centre section of convertible roof compartment from side section (right-side) (4).
5. Pull apart side sections (1) and (2).

6. Remove bolts (3) (4x) from inside lid.
7. Detach inside lid (1).
8. Unscrew bolts (1) (4x) on both sides.
9. Pull apart sections (1) and (4) upwards.
10. Prise sliders (3) out of fastening mechanism of section (1).
11. Separate sections (1) and (4).
12. Unscrew bolts (2) (3x).
13. Take out rack (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mechanically driven air conditioner compressor, vehicles with high-voltage system
• Removing and installing air conditioner compressor - vehicles with 8-cyl. FSI/TFSI engine
• Renewing bonded rubber bush (front) for rear final drive, four-wheel drive vehicles
• Removing and installing brake pads - steel version brakes (1LM / 1LX)
• Removing and installing cylinder head cover (left-side) - vehicles with two turbochargers