Removing left and right convertible top compartment lid locks — AUDI
Removing left and right convertible top compartment lid locks on Audi: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H)
Don't miss
- Mark the exact installation positions of the bolts (3) and remove the bolts.
- The connector is located behind the belt retractor.
- Make sure the convertible top compartment lid is aligned with the side panel after closing.
📋 Procedure
- Remove the rear seat bench and backrest 72.
- ⚠ Observe the safety regulations for handling pyrotechnic belt tensioners 69. — Remove the relevant rear belt retractor 69.
- Unplug connector behind belt retractor.
- Move the convertible top to the centre position.
- Remove the clips for the front trim of the convertible top compartment unit to the extent required for access to the convertible top compartment lock.
- Remove the lock washer (1).
- Detach the connecting rod (2).
- Mark the exact installation positions of the bolts (3) and remove the bolts.
- Unscrew the convertible top compartment lid lock and lay it aside.
- Unplug the connector of the switch unit and take out the switch and lock. [Note: The connector is located behind the belt retractor.]
- Tighten the bolts exactly to the marks made beforehand to avoid having to adjust the locks.
- Make sure the convertible top compartment lid is aligned with the side panel after closing.
- Check whether switches function with convertible top compartment lid closed.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing insert for centre console – Audi A3
- Removing and installing centre armrest (top section) – Audi
- Removing and installing child seat anchor (rear) – Audi
- Removing and installing key operated switch to deactivate front passenger side airbag
- Removing and installing side airbag (front) with airbag igniter - multi-contour seat
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.