Removing bevel box, Audi S1: Audi A1
Step-by-step removing bevel box, Audi S1 for the Audi A1: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
Don't miss
- Make sure you do not damage surface coating on drive shaft.
- Make sure you do not damage surface coating on propshaft.
- Using socket and extended bit T10107 A, remove bolt securing flange shaft (right-side). To do so, screw two bolts into flange and counterhold flange shaft with suitable lever.
📋 Procedure
- Remove subframe with steering rack Running gear, axles, steering40Subframe; Removing and installing subframe with steering rack.
- Remove catalytic converter with front silencer 26Emission control system; Removing and installing catalytic converter.
- Remove nuts (arrows) and detach heat shield (1) for drive shaft (right-side).
- Detach drive shaft (right-side) Running gear, axles, steering40Drive shaft; Removing and installing drive shaft.
- Tie up drive shaft towards rear. [Note: Make sure you do not damage surface coating on drive shaft.]
- Remove nuts (arrows) and detach heat shield (1).
- Press propshaft off bevel box and tie up Rear final drive39Propshaft; Removing and installing propshaft. [Note: Make sure you do not damage surface coating on propshaft.]
- Remove bolts (1, 2) and detach bracket for bevel box.
- Using socket and extended bit T10107 A, remove bolt securing flange shaft (right-side). To do so, screw two bolts into flange and counterhold flange shaft with suitable lever.
- Remove bolts (arrows) securing bevel box to gearbox.
- Carefully push bevel box away from gearbox, making sure it does not fall down.
- Pull off bevel box together with flange shaft (right-side).
- Install bevel box .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Exploded view - sump (2-part)
- Removing and installing exhaust gas temperature sender 3 G495/exhaust gas temperature sender 4 G648
- Checking fuel gauge sender G - vehicles with high-voltage system
- Removing and installing fuel pump control unit J538 - vehicles with high-voltage system
- Checking wiring and components with isolator box, 198-pin VAS 6606
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.