TorqFix

Removing belt adjuster (rear): Audi A6 C5

Step-by-step removing belt adjuster (rear) for the Audi A6 C5: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

6 steps 1 torque figure

🧭 Before you start

Fits: Audi A6 C5 (4B)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

TorqueFastener / step
55 Nm (41 lb-ft)Unfasten bottom anchorage point of rear three-point seat belt

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

  1. Unfasten bottom anchorage point of rear three-point seat belt (tightening torque 55 Nm). — 55 Nm (41 lb-ft)
  2. Unclip belt guide trim (3).
  3. Pry out belt adjuster trim (2) at lug (7) (left and right).
  4. Fold arm of belt adjuster (4) upwards with belt.
  5. Use screwdriver to press in retaining tabs (1) (2x) and at the same time pull belt adjuster (2) upwards.
  6. Pull belt through belt adjuster (2).

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.