Removing and installing windscreen wiper frame with linkage and windscreen wiper motorV — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

📋 Procedure

1. Deactivate APP function .
2. Move windscreen wipers to park position. Then, switch off ignition and all electrical loads, and pull out ignition key.
3. Disconnect battery .
4. Remove plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.
5. Removing wiper arm .

6. Undo and remove bolts (arrows) securing trim (1).
7. Remove trim (1) from vehicle.
8. Remove securing bolts (1).
9. Release and disconnect connector (3).
10. If necessary, remove wire retainer/s from wiper frame (2).
11. Take wiper frame (2) with linkage and wiper motor out of plenum chamber.
12. When installing, fit guide pin located on back of windscreen wiper frame into grommet (arrow) on plenum chamber bulkhead.
13. Push connector onto connection of windscreen wiper motor and engage it.
14. Tighten securing bolts for wiper frame incrementally in sequence (1 - 3).
15. Install air duct trim.
16. Connecting battery .
17. Install plenum chamber cover General body repairs, exterior50Bulkhead; Removing and installing plenum chamber cover.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Draining and filling cooling system - vehicles without hybrid drive
• Removing and installing brake pads (18" Plus, PR 1LT and 1LU) · 1 torque figures
• Removing and installing rear brake pads (PR 1KD) – Audi Q7 · 1 torque figures
• Removing and installing compressor (vehicles with 12-cyl. TDI engine) · 1 torque figures
• Removing and installing wheel hub and wheel bearing – Audi Q7 · 1 torque figures