Removing and installing wheel housing extension for wing — AUDI
Removing and installing wheel housing extension for wing on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
Don't miss
- Before removing, gently heat wheel housing extension for wing (1) in bonded area using hot air blowerV.A.G 1416 .
📋 Procedure
- Remove bolt (2).
- Before removing, gently heat wheel housing extension for wing (1) in bonded area using hot air blowerV.A.G 1416 .
- Carefully fit removal wedge3409 between wheel housing extension (1) and wing.
- As soon as adhesive joint comes loose, carefully pull wheel housing extension (1) off wing.
- Observe repair instructions .
- Insert wheel housing extension for wing (1) into side member extension.
- Fit wheel housing extension (1) to wing, and align it with front bumper cover.
- Pull protective film (3) off double-sided adhesive tape.
- Firmly press on wheel housing extension for wing (1) in bonding area.
- Start and tighten bolt (2).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.