Removing and installing wheel bearing unit - Audi A1 quattro — AUDI
Removing and installing wheel bearing unit - Audi A1 quattro on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
📋 Procedure
- Before commencing work, measure distance from wheel centre to lower edge of wheel housing and note measured value .
- Remove coil spring .
- Remove drive shaft .
- Remove brake disc Brake system46Rear brakes; Removing and installing brake disc.
- Remove bolts (arrows).
- Pull wheel bearing unit out of wheel bearing housing.
- ⚠ Avoid dirtying or damaging the seal when laying it down or placing it in storage. — Install and tighten new bolt .
- Install drive shaft .
- Install spring .
- Overview table: when does wheel alignment have to be checked?
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Performing zero compensation of brake pressure sender 1 G201 and brake pressure sender 2 G214
- Dismantling and assembling auxiliary heater (version “1”, horizontal installation)
- Dismantling and assembling auxiliary heater (version “2”, vertical installation)
- Poly V-belt drive for power steering pump, alternator and air conditioner - exploded view of components
- Removing and installing input shaft, output shafts (pinion shafts), differential, bevel box and selector rods - gearboxes to approx. 04.2003
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.