Removing and installing upper A-pillar trim: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Always keep to the A-pillar trim installation sequence. — Guide in the upper A-pillar trim (1) at the front between the rubber door seal and side panel.
• Make sure the trim is a firm fit. — Make sure the rubber door seal is properly fitted over the upper A-pillar trim.

📋 Procedure

1. ⚠ Heed the safety regulations for pyrotechnic components . — Remove the sun visor .
2. Remove the roof grab handle .
3. Loosen the D-pillar trim and fold it aside.
4. Unscrew the bolt (4).
5. Unfasten the upper A-pillar trim (1) from the clips (2) (2x).

6. Pull the upper A-pillar trim (1) to the rear out of the retainer (3).
7. ⚠ Always keep to the A-pillar trim installation sequence. — Guide in the upper A-pillar trim (1) at the front between the rubber door seal and side panel.
8. Guide the trim retainer (3) into the corresponding clip.
9. Secure the upper A-pillar trim (1) with the two clips (2) (2x).
10. Screw in the bolt (4).
11. ⚠ Make sure the trim is a firm fit. — Make sure the rubber door seal is properly fitted over the upper A-pillar trim.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing electronically controlled damping control unit J250 · 2 torque figures
• Removing and installing battery in luggage compartment – Audi
• Removing and installing fuel gauge sender 2G169 – Audi A8 D4
• Removing and installing fuel delivery unit/fuel gauge senders, all vehicles except versions for China
• Removing and installing moulded headliner - A3 Sportback