Removing and installing (up to MY 02): Audi A4 Cabriolet B6/B7
Step-by-step removing and installing (up to MY 02) for the Audi A4 Cabriolet B6/B7: 7 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Unscrew bolts (3 |
| 3 Nm (2.2 lb-ft) | Unscrew nuts (2) and (4 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove luggage compartment side trim (right-side) General body repairs, interior70Luggage compartment trim panels.
- Unplug connectors (2) at aerial amplifier for mobile telephone R86(1).
- Unscrew nuts (2) and (4) (3 Nm) and remove aerial amplifier for mobile telephone R86(1) with bracket (5). — 3 Nm (2.2 lb-ft)
- Unscrew bolts (3) (3 Nm) and detach aerial amplifier for mobile telephone R86(1) from bracket (5). — 3 Nm (2.2 lb-ft)
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Renewing electric height adjuster on seats with upper section laser-welded to seat rail (new version)
- Removing and installing seat cushion extension – Audi A6 C5
- Removing and installing four-way lumbar support control motors
- Removing and installing seat cushion cover and padding (standard seat)
- Removing and installing wiper mounting - vehicles up to 10.2004
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.