Removing and installing three-point seat belt with belt tensioner (front) — AUDI
Removing and installing three-point seat belt with belt tensioner (front) on Audi: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H)
📋 Procedure
- ⚠ Observe measures when disconnecting the battery Electrical system27. — Disconnect battery.
- Remove rear seat bench .
- Remove rear seat backrest .
- Remove side trim .
- Unscrew bolt (5).
- Unplug connector for belt tensioner .
- Remove outer floor panel anchorage point (6).
- Unclip belt guide (1).
- Pull belt (2) out of belt guide (1).
- Take out belt reel (4).
- Install seat belt (front) in reverse order of removal.
- Pull off retaining clip (4).
- Unplug connector (3).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking activated charcoal filter solenoid valve 2N115
- Checking fuel system diagnostic pump V144 – Audi TT Mk1 1.8
- Removing and installing turbocharger- engine codes AVB, AVF, AWX and BKE
- Checking air recirculation valve for turbocharger N249 - vehicles with electronic throttle
- Installing gearbox - vehicles with 4-cylinder or 6-cylinder engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.