Removing and installing telephone roof aerial - Coupe (up to MY 01) — AUDI

🧭 Before you start

Fits: Audi TT Mk1 (8N)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical consumers.
2. Remove ignition key.
3. Remove roof end trim: General Body Assembly, Interior70.
4. Detach connection (1) of aerial cable from aerial base (2).
5. Unscrew hexagon nut (3) (4 Nm) to permit removal of aerial sections (4) and (5). — 4 Nm (3.0 lb-ft)
6. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking and converting adapter for back pressure test on natural gas tank, solenoid secured with securing nut · 1 torque figures
• Emptying fuel tank, all-wheel drive - engine code CFHC, CFHF, CLCA, CUUB, CUUC, CUUD, CUUE, CUUF
• Removing and installing axle beam, all wheel drive
• Removing and installing front 3-point seat belt · 1 torque figures
• Removing and installing brake pads, floating caliper disc brake FN3