Removing and installing telephone operating electronics control unit, vehicles up to 06.2012 — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove centre console General body repairs, interior68Centre console; Removing and installing centre console. [Note: The vehicle carpet must be cut to gain access to the mobile telephone operating electronics control unit J412.Using commercially available scissors, cut the carpet and the insulation below the carpet along the marked cut line.When doing this, slightly lift the carpet and make sure that the lines below the cut line are not damaged.]
3. Using scissors, carefully cut vehicle carpet and insulation below carpet along dashed line (3).
4. Pull out section of carpet (2) together with insulation from underneath storage compartment in dash panel (1) towards right into front passenger footwell.
5. Release catch (2), and pull mobile telephone operating electronics control unit J412(3) towards side out of mountings in bracket (1).

6. Release and disconnect connector (4).
7. Take out control unit.
8. Connect connector (4), and lock it.
9. Fit mobile telephone operating electronics control unit J412(3) on right side into bracket (1), and then engage it firmly on left side (2).
10. Fit vehicle carpet with insulation back in their original position below storage compartment in dash panel.
11. Use commercially available adhesive tape to join the two halves of the vehicle carpet and to prevent them from being shifted relative to each other.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing throttle valve positioner sender and throttle valve potentiometer
• Checking intake manifold change-over valve – Audi 1.6
• Servicing injection system – Audi 1.6
• Testing lambda probe (before catalytic converter) for ageing
• Checking misfiring recognition