Removing and installing telephone bracket R126 (front centre armrest) — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Open front centre armrest.
4. Remove telephone handset R36 from telephone bracket R126.
5. Remove SIM card from telephone bracket R126.

6. Use removal wedge3409 to carefully pry storage compartment off trim and bottom cover.
7. Unplug connectors and remove storage compartment.
8. Unscrew bolts (1) and (2) (2 Nm) on reverse side and unplug connector (arrow). — 2 Nm (1.5 lb-ft)
9. Press telephone bracket R126 out of storage compartment.
10. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing headlights - vehicles from model year 2014 onwards
• Adjusting LED headlights - rest-of-the-world vehicles up to model year 2013
• Removing and installing relay and fuse holder in electronics box
• Removing and installing water radiator (front) for charge air cooling circuit
• Removing and installing water radiator (left-side) for charge air cooling circuit