Removing and installing telephone aerial R65 (glass roof panel) — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

Don't miss

• Mark position of top and bottom part.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove rear interior light General body repairs, interior69.
4. Unplug connector at bottom part of aerial.
5. Use suitable tool to prise off bottom and top part of aerial.

6. Mark position of top and bottom part.
7. Clean bonding surfaces with adhesive remover D 002 000 10 or cleaning agent D 009 004 04.
8. Remove backing from bonding surfaces of top and bottom part.
9. Press top part (2) and bottom part (3) onto marked position on glass panel. Apply pressure for approx. 5 seconds.
10. Whilst twisting gently, push cap (1) onto top part of aerial (2) until it is firmly attached.
11. Plug in connector.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front turn signal bulb M5/M7 - gas discharge headlights from model year 2013 onwards
• Removing and installing headlight range control motor V48/V49 - halogen headlights up to model year 2012
• Removing and installing LED module for daytime running light and side light L176/L177 - gas discharge headlights from model year 2013 onwards
• Checking condensation drain (front) – Audi Q7
• Removing and installing lower suspension link