Removing and installing tail light cluster on rear lid: Audi A6/A7 C7

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

Don't miss

• Complete inner tail light cluster must be renewed if LED is defective.Ensure that seal between body and tail light housing seals completely.

📋 Procedure

1. Turn light switch to position "“0”".
2. Extend spoiler Owner's Manual for the vehicle.
3. Remove rear lid trim (bottom) General body repairs, interior70Luggage compartment trim panels; Removing and installing rear lid trim (bottom).
4. Unplug electrical connector (2).
5. Remove nut (1).

6. Pry out covers (1) using wedge T10383/1.
7. Remove bolts (4).
8. Carefully remove cover (3) at the side (arrow), this will release retaining tabs (1, 2).
9. Detach inner tail light cluster (5). [Note: Complete inner tail light cluster must be renewed if LED is defective.Ensure that seal between body and tail light housing seals completely.]
10. Fit inner tail light cluster (6) at attachment (5) for rear lid.
11. Tighten nut (1) while pressing against tail light cluster from inside.
12. Plug in electrical connector (2).
13. Tighten bolts (4) and press on cover (3) until it engages audibly.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing auxiliary air heater Airtronic D3
• Removing and installing alternator, 3.2 l V6 engine
• Removing and installing alternator, 1.9 l TDI engine
• Removing and installing tachograph sender, 5-speed manual gearbox · 1 torque figures
• Removing and installing front door trim, front passenger side