Removing and installing suspension link with mounting bracket — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• The locating pins T10096 may be tightened only to a maximum of 20 Nm; otherwise the threads of the locating pins may be damaged.
• Position bolt (17), but do not tighten it yet.
• Sealing boot of suspension link must not be damaged or twisted.
• Tighten new bolt (17) for suspension link to bracket only when the vehicle is standing on its wheels and is unladen or if the vehicle is raised and is in the unladen position (normal position) .

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove front left wheel.
2. Remove lower noise insulation General body repairs, exterior50.
3. Remove bolts (arrows).
4. Pull wheel bearing housing with swivel joint out of suspension link.
5. Fix position for mounting bracket

6. Replace bolt (1) on left side by locating device T10096 and tighten it to 20 Nm. [Note: The locating pins T10096 may be tightened only to a maximum of 20 Nm; otherwise the threads of the locating pins may be damaged.] — 20 Nm (15 lb-ft)
7. Remove bolt (17).
8. Remove bolts (1).
9. Take suspension link and mounting bracket off subframe.
10. Insert suspension link with mounting bracket into subframe.
11. Position bolt (17), but do not tighten it yet.
12. Insert bolts (1) and tighten them.
13. Replace locating pin T10096 with a new bolt and tighten.
14. Screw suspension link firmly onto swivel joint (arrows). [Note: Sealing boot of suspension link must not be damaged or twisted.]
15. Tighten new bolt (17) for suspension link to bracket only when the vehicle is standing on its wheels and is unladen or if the vehicle is raised and is in the unladen position (normal position) .

🎬 Related video tutorial

Independent AUTODOC tutorial for the same job, filmed on a different model (80 B4) — the technique carries over, the fasteners and figures on this page are the ones for your car.

How to change front lower arm on AUDI 80 B4 TUTORIAL

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures