Removing and installing support mounting (right-side): Audi Q7 (CRTC, CVMD, CVZA, CZZA)

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

Don't miss

• Disregard (item 3).
• To detach the support mounting (right-side), the engine must be lifted slightly on the left side.

🔧 Engine codes this applies to

📋 Procedure

1. Remove rubber overlay (1) from gearbox support T10337.
2. If not already done, drill a hole in the centre ∅ = 10.2 mm (arrow).
3. Tap M12 thread into hole.
4. Remove noise insulation (front) General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
5. Detach electrical connector (2) from bracket.

6. Remove bolt (1) from support mounting (left-side). [Note: Disregard (item 3).]
7. Remove bolts (arrows) for support mounting (right-side) (1). [Note: To detach the support mounting (right-side), the engine must be lifted slightly on the left side.]
8. Secure tapered mounting pinVAS 6131/10-2 to gearbox support T10337.
9. Attach engine and gearbox jackVAS 6931 to engine, as shown in illustration.
10. Raise engine slightly until support mounting (right-side) can be removed towards left side.

Other AUDI procedures

• Removing and installing charge air cooler (right-side) – Audi
• Draining reducing agent tank – Audi A8 D4
• Draining fuel tank if more than 3/4 full - TDI vehicles – Audi
• Renewing camshaft – Audi Q7
• Removing and installing intake manifold flap motor V157 – Audi
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures