Removing and installing support bracket for centre armrest (front) — AUDI
Removing and installing support bracket for centre armrest (front) on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
📋 Procedure
- Remove centre armrest (front) .
- Remove centre console (rear) .
- Remove centre console (front) .
- Unscrew bolts (1) and (2) and nuts (3).
- Unhook floor covering on sides of mounting frame for centre console (arrows).
- Lift mounting frame for centre console out of studs and pull off towards the rear.
- Unscrew nuts (arrows) and detach support bracket for centre armrest (front).
- Install mounting frame for centre console .
- Install centre console (front) .
- Install centre console (rear) .
- Install centre armrest (front) .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing timing chain cover (top left) – Audi
- Removing and installing seat ("High") - outer seats in 2nd row
- Removing and installing guide link – Audi
- Removing and installing control motor V107 with "“Low”" air conditioner (and heater with no air conditioner)
- Removing and installing cover for mechatronic unit
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.