Removing and installing storage well liner: Audi A6 C6
Step-by-step removing and installing storage well liner for the Audi A6 C6: 17 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
📋 Procedure
- Remove luggage compartment floor (1) and cover for moulded insert (deep version) (2).
- ⚠ Observe safety precautions for working on airbags , side airbags and curtain airbags . — Remove rear seat bench .
- Remove side airbag .
- Remove luggage compartment side trim .
- If fitted, release retaining clips (arrows A) and pivot trailer detector control unit J345(item 1) out slightly.
- Release retaining clip (arrow B) and pivot trailer detection control unit J345 out of retaining frame.
- Move trailer detection control unit J345 clear to one side with electrical wires (2 ... 4) connected.
- If fitted, release retaining clip (arrow) and pivot parking aid control unit J446(item 4) out of retaining frame.
- Move parking aid control unit J446 clear to one side with electrical wires (1 ... 3) connected.
- Remove spreader pins (arrows) and detach cover plate (1).
- Remove accumulator Running gear, front-wheel drive and four-wheel drive43.
- Unscrew bolts and detach mountings for retaining rail for fastening rings.
- Remove storage well liner.
- Install accumulator Running gear, front-wheel drive and four-wheel drive43.
- Install luggage compartment side trim .
- Install side airbag .
- Install rear seat bench .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing entry and start authorisation control unit J518
- Removing and installing headlight range control regulator E102
- Removing and installing rear lid handle release button E234 - Saloon
- Removing and installing anti-theft alarm sensor G578 - Cabriolet
- Removing and installing reversing camera R189 - Cabriolet
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.