Removing and installing steering column switch module, version with mechanical ignition lock — AUDI
Removing and installing steering column switch module, version with mechanical ignition lock on Audi: 13 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q3 (8U, 2011–2018); platform code 84
📋 Procedure
- Move steering wheel down and to rear as far as possible, making use of full range of steering column adjuster.
- Remove airbag (driver side) General body repairs, interior69Airbag (driver side); Removing and installing airbag unit with igniters.
- Remove steering wheel Running gear, axles, steering48Steering wheel; Removing and installing steering wheel.
- Remove trim for steering column switch module General body repairs, interior68Shelves / trim panels; Exploded view - steering column trim.
- Pull out connector locking element (4), press down release mechanism and unplug electrical connector (3).
- ⚠ Risk of irreparable damage to electronic components due to static discharge.Before disconnecting the electrical connection, the mechanic must discharge static by briefly touching striker plate for door or similar. — Pull out connector locking element (1), press down and unplug electrical connector (2).
- Apply screwdriver (1) at retaining hook (2), as shown in illustration, and carefully release electrical connector (3).
- Release retaining tab (3) with a small screwdriver.
- Press catches (1) and pull off steering column switch module (2).
- Press on steering column switch module until it engages audibly at steering lock housing.
- Install trim for steering column switch module General body repairs, interior68Shelves / trim panels; Exploded view - steering column trim.
- Install steering wheel Running gear, axles, steering48Steering wheel; Removing and installing steering wheel.
- Install airbag (driver side) General body repairs, interior69Airbag (driver side); Removing and installing airbag unit with igniters.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.