Removing and installing starter - vehicles with 3.0 ltr. biturbo TDI engine — AUDI

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

📋 Procedure

1. Remove alternator .
2. Remove bolt (arrow).
3. Remove engine mountings 10Assembly mountings; Removing and installing engine mountings.
4. Remove nut (1) and move earth cable clear at engine support.
5. Remove bolts (arrows) and detach engine support (right-side).

6. Unplug connector (2) by sliding locking element to rear and pressing down release catch.
7. Unscrew nut (4) and detach B+ wire (3) from solenoid switch.
8. Remove bolt (5) and detach starter (1).
9. Install engine support and engine mounting (right-side) 10Assembly mountings; Exploded view - assembly mountings.
10. Install alternator .
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing belt buckles of 3-person bench seat, Transporter
• Removing and installing right dash panel trim, Transporter
• Removing and installing front side panel trim, Multivan
• Removing and installing rear side panel trim, hardboard-type, Transporter
• Removing and installing backrest of 3-person bench seat, Transporter