Removing and installing starter - vehicles with 2.7 ltr. and 3.0 ltr. TDI engine — AUDI
Removing and installing starter - vehicles with 2.7 ltr. and 3.0 ltr. TDI engine on Audi: 18 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 (8T, 2007–2016)
Don't miss
- Disregard (item 3).
- (Item 1) is accessible from above.
📋 Procedure
- With ignition switched off, disconnect earth cable at battery .
- Vehicles up to identification no. 8T-8-009 998: Remove particulate filter 26Emission control system; Removing and installing particulate filter.
- Vehicles from identification no. 8T-8-009 999 onwards: Remove front exhaust pipe 26Exhaust pipes/silencers; Removing and installing front exhaust pipe.
- Remove alternator: vehicles without auxiliary heater ; vehicles with auxiliary heater .
- Remove engine mounting (right-side) 10Assembly mountings; Exploded view - assembly mountings.
- Remove bolts (1) and (2).
- Press bottom right coolant pipe to one side. [Note: Disregard (item 3).]
- Remove nut (1) and move earth cable clear at engine support (right-side).
- Remove bolts (arrows) and detach engine support (right-side).
- Unplug connector (3) by sliding locking element to rear and pressing down release catch.
- Unscrew wire (2) at starter.
- Unscrew bolts (1) and (4) and remove starter. [Note: (Item 1) is accessible from above.]
- Install engine support and engine mounting (right-side) 10Assembly mountings; Exploded view - assembly mountings.
- Install coolant pipe (bottom right) 19Coolant pipes; Removing and installing coolant pipes.
- Install alternator: vehicles without auxiliary heater ; vehicles with auxiliary heater .
- Vehicles up to identification no. 8T-8-009 998: Install particulate filter 26Emission control system; Removing and installing particulate filter.
- Vehicles from identification no. 8T-8-009 999 onwards: Install front exhaust pipe 26Exhaust pipes/silencers; Removing and installing front exhaust pipe.
- Connect battery. Steps required .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking drive data bus
- Removing and installing right heat exchanger (front passenger's side)
- Checking fuel pump
- Removing and installing engine
- Removing and installing convertible top cover and seals
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.