Removing and installing starter, 3.2 l V6 engine — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Unscrew securing bolts (1) of coolant expansion tank and push coolant expansion tank to one side.
3. Remove noise insulation General body repairs, exterior50Body front; Noise insulation.
4. If necessary, lever off protective cap (2) of positive cable fastening from starter solenoid switch.
5. Unscrew securing nut (3) of positive cable (terminal 30) from starter solenoid switch and push cable to one side.

6. Release and disconnect connector (terminal 50). (1) on starter solenoid switch.
7. Unscrew securing nut (5) of negative cable (terminal 31) (4) and push cables to one side.
8. Unscrew securing nut (3) of cable retainers (2) and push cables to one side.
9. Unscrew securing bolts (1) for starter.
10. Remove starter.
11. Observe specified torques Assembly overview - starter.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures