Removing and installing spray jet pop-up cylinders — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• Collect leaking fluid in accordance with regulations.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Removing spray jet retainer .
3. Remove radiator grille General body repairs, exterior66Removing radiator grille and emblem.
4. Remove plastic cover (1).
5. Unscrew securing bolts on headlight trim (arrows).

6. Pull headlight trim (arrows) out of guides and remove it.
7. Unscrew the three securing bolts (arrows).
8. Detach clip (arrow) and pull hose off pop-up cylinder. [Note: Collect leaking fluid in accordance with regulations.]
9. Remove pop-up cylinder together with retainer.
10. Unscrew the two securing bolts (arrows) and remove pop-up cylinder from retainer.
11. Install spray jet retainer .
12. Adjusting headlight washer system jets .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Separating engine and gearbox - dual clutch gearbox 0B5 · 2 torque figures
• Separating engine and gearbox - vehicles with multitronic gearbox · 2 torque figures
• Separating engine and gearbox - vehicles with dual clutch gearbox 0CK · 2 torque figures
• Removing gearbox - vehicles with 8-cyl. 4.2 ltr. TDI engine
• Removing and installing suction-jet pumps – Audi Q7