Removing and installing silencers, engine code DAJB: Audi A1 (CWZA, DAJB)

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

🔧 Engine codes this applies to

📋 Procedure

1. Press coupling rod of rear left vehicle level sender G76 off ball stud (2)(arrow).
2. Remove bolt (1) and press bracket (2) with rear left vehicle level sender G76 to one side.
3. Remove tunnel cross-piece (rear) General body repairs, exterior66Underbody trim; Exploded view - underbody trim.
4. Vehicles without connection point: separate exhaust pipes/silencers .
5. Vehicles with connection point: release clamp (arrows) and push to right side.

6. Remove bolt (2) and detach centre silencer.
7. Vehicles without connection point: separate exhaust pipes/silencers .
8. Vehicles with connection point: release clamp (arrows) and push to right side.
9. Unscrew bolts (1, 3) and detach rear silencer (2).
10. Align the exhaust system so it is free of stress .

Other AUDI procedures

• Removing and installing engine control unit J623 without protective housing
• Removing and installing stage 3 oil pressure switch F447
• Removing and installing Hall sender 3G300 – Audi A6/A7 C7
• Draining fuel tank - vehicles with front-wheel drive – Audi A1
• Removing and installing engine control unit J623 with protective housing
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures