TorqFix

Removing and installing senders for parking aid (front) - vehicles from 11.2004 — AUDI

Removing and installing senders for parking aid (front) - vehicles from 11.2004 on Audi: 10 steps. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

📋 Procedure

  1. On vehicles with auxiliary heater, unscrew bolts (arrows) for exhaust pipe of auxiliary/supplementary heater at noise insulation.
  2. Unfasten bolts/quick-release fasteners (1) and (2) and detach noise insulation (front).
  3. Remove front bumper cover 63.
  4. Remove front bumper cover 63.
  5. Remove radiator grille 63.
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Unplug electrical connector (1) at sender.
  2. Press both retaining tabs aside (arrows) and press out sender (2) inwards.
  3. Install front bumper cover 63.
  4. Install front bumper cover 63.
  5. Install radiator grille 63.

Other AUDI procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.