Removing and installing selector lever lock solenoid N110 — AUDI
Removing and installing selector lever lock solenoid N110 on Audi: factory workshop procedure. Full factory text, tools and checks.
Workshop procedure for AUDI — the factory write-up, straight from real workshop data.
📋 Procedure
Removing and installing
selector lever lock solenoid
N110
Removing
Remove mounting frame with
multimedia system operating unit
E380
1
General body repairs, interior
Rep. Gr.
68
Detach electrical connector
1
.
Detach insulation
2
for selector housing.
Remove front ashtray/front storage compartment
General body repairs, interior
Rep. Gr.
68
.
Unscrew bolts
arrows
and
1
securing centre console bracket.
Detach electrical connector
1
.
Remove the four bolts
arrows
.
Remove the four bolts
arrows
.
Note
For illustration purposes shown without centre console bracket.
Tilt shift unit and remove centre console bracket.
Press parking lock
C
downwards and hold.
Shift selector lever to position
“S”
.
Unplug electrical connector
1
from
selector lever lock solenoid
N110
.
Note
Slightly lift solenoid at the front to disengage ball head
2
from operating lever
1
.
For illustration purposes here shown with selector mechanism removed.
Release retainer
arrow A
and pull out
selector lever lock solenoid
N110
from the front
arrows B
.
Installing
Selector lever in position
“S”
.
Unclip guide funnel for manual release lever and detach sideways in direction of
arrow
.
Move manual release lever
arrow
upwards.
Note
The operating lever
1
for
selector lever lock solenoid
N110
moves into installation position when the manual release lever is moved upwards.
At the same time place the
selector lever lock solenoid
N110
into guide at an angle from above.
Press
selector lever lock solenoid
N110
into guide until it engages.
At the same time the ball head
2
of the
selector lever lock solenoid
N110
should engage in the operating rod of the selector mechanism.
Plug in connector
1
.
Checking function of
selector lever lock solenoid
N110
(before carrying out remaining steps for installation)
Plug in connector
1
.
Plug in connector
1
.
Check function of
selector lever lock solenoid
N110
in position
“P”
and
“N”
before carrying out remaining steps for installation
Chapter
“
Checking operation of selector mechanism
”
.
The remaining installation steps are carried out in reverse sequence (according to steps for installation of shift unit)
Chapter
.
TorqFix answers live for your specific car — tell it the engine code and it serves the matching sequence, torque figures and wiring for that exact variant.
Ask about my car →Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.