Removing and installing selector cable: Audi TT Mk2

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

📋 Procedure

1. Remove selector mechanism .
2. Open out tabs (arrows) on floor plate all round with screwdriver and remove floor plate.
3. Detach gasket from selector mechanism.
4. Pull off securing clips (2) and (3).
5. Prise gear selector cable (1) and gate selector cable (4) off pins, e.g. using release tool T10236.

6. Detach gear selector cable and gate selector cable from selector housing.
7. Push locking sleeve forwards onto stop (arrow 1) and turn fully clockwise (arrow 2) so that it engages.
8. Detach cable end-pieces from selector cables.
9. Remove securing clips (1) and (2).
10. Detach cable support bracket from selector cables.
11. Secure gear selector cable and gate selector cable to selector housing with securing clips (2 ... 3).
12. Press gear selector cable (1) and gate selector cable (4) onto pins.
13. Secure floor plate to selector housing .
14. Secure gear selector cable and gate selector cable with cable tie .
15. Install selector mechanism .
16. Adjust selector mechanism .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures