Removing and installing seat cushion of seat bench: Audi Q7

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• Make sure bracket of seat cushion (4) is properly engaged in mounting (3).
• The retainers (5) must always be renewed after removing the seat cushion. — Make sure that seat cushion (1) is properly clipped into retainers (5) at front.

📋 Procedure

1. Take photographs or make sketches of the wiring attachment and routing.
2. Unplug connectors for seat heating .
3. Remove ISOFIX caps (2).
4. Pull front edge of seat cushion (1) upwards out of retainer (5) on left and right.
5. Swivel seat cushion (1) as far as backrest (2).

6. Disengage bracket of seat cushion (4) from mounting (3) (left and right).
7. Take seat cushion (1) out of vehicle.
8. Make sure bracket of seat cushion (4) is properly engaged in mounting (3).
9. ⚠ The retainers (5) must always be renewed after removing the seat cushion. — Make sure that seat cushion (1) is properly clipped into retainers (5) at front.
10. Plug connectors into connector couplings .
11. Route and secure the wiring according to the photographs taken or sketches made earlier.
12. Clip wiring strain relief clamp into coupling point.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures