Removing and installing seat cushion: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

Don't miss

• The two seat springs and the corresponding rear rubber buffers between seat cushion and backrest drop out on removal.
• Make sure rubber buffers (9) are correctly positioned in mounts at backrest.

📋 Procedure

1. Remove seat .
2. Remove spring cover .
3. Pull out fastener (3) of holders (2) (2x) (detail (D)).
4. Disengage holders (2) (2x) to front.
5. Sever cable ties (4) (detail (C)).

6. Unplug heated backrest connector (5).
7. Press retainer tabs (6) to remove connector (7).
8. Unplug airbag connector (8)
9. Remove height adjustment handle .
10. Disengage trim for cover (11) (detail (B)).
11. Fold up seat cushion (1) at front.
12. Pull out seat cushion (1) to front.
13. Detach seat cushion padding . [Note: The two seat springs and the corresponding rear rubber buffers between seat cushion and backrest drop out on removal.]
14. Make sure rubber buffers (9) are correctly positioned in mounts at backrest.
15. Position seat cushion (1) on frame and place springs (10) at an angle between rubber buffer (9) and seat cushion (1) (detail (A)).
16. Pull seat cushion (1) to rear at trim for cover (11) until springs (10) are straight (detail (B)).
17. Press retainer tab (2) and unplug connector (1) in direction of arrow.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking vacuum pump for brakes V192 – Audi A8 D3
• Removing and installing gearbox - vehicles with 12-cylinder 6.0 ltr. MPI engine (W12)
• Removing and installing gas strut for centre armrest – Audi
• Removing and installing third rear three-point seat belt (fixed rear seat backrest)
• Removing and installing front deformation element – Audi A8 D3