Removing and installing seat base frame with longitudinal adjustment motor — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Ensure correct operation of the safety latch . — Install the seat base frame with longitudinal adjustment motor (7) in the reverse order of removal.

📋 Procedure

1. Removing seat with defective longitudinal adjustment motor .
2. Unscrew the bolts (4) (2x).
3. Detach the retainer plate for the safety latch (3).
4. Unscrew the bolts (8) (2x).
5. Unscrew the bolts (2) (2x).

6. Disengage the seat longitudinal adjustment motor (5) from the shafts (1) and (6).
7. Move both runners with a power screwdriver and a long shaft until the concealed bolts (8) (2x) become visible.
8. Unscrew the bolts (8) (2x).
9. Replace the seat base frame with longitudinal adjustment motor (7).
10. ⚠ Ensure correct operation of the safety latch . — Install the seat base frame with longitudinal adjustment motor (7) in the reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing waste water tank
• Removing and installing alternator, vehicles with 5-cylinder diesel engine · 1 torque figures
• Removing and installing radio system "“RSD 2000”" · 1 torque figures
• Removing and installing radio system "“RSD 4000”" and radio navigation system "“RNS 6000”" · 1 torque figures
• Removing and installing drive shaft, Crafter 4MOTION with Achleitner four-wheel drive