Removing and installing roof aerial R216 (USA): Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Make sure that the lug (1) engages properly in the opening in the roof.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove roof end trim General body repairs, interior70.
4. Remove C-pillar trim (left and right) General body repairs, interior70.
5. Remove rear interior light W43Electrical system96.

6. Pull down moulded headlining (rear) General body repairs, interior70.
7. Unplug connectors of aerial wires (2) and (4).
8. Unscrew nut (3) (6 Nm). — 6 Nm (4.4 lb-ft)
9. Lift radio, telephone and navigation system aerial R52 off roof.
10. Guide the aerial wires (2) and (4) through the roof.
11. Make sure that the lug (1) engages properly in the opening in the roof.
12. Perform further installation in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing balance shaft (inlet side) – Audi Q3
• Removing and installing front exhaust pipe – Audi TT Mk1
• Removing and installing front seat – Audi Q7
• Removing and installing rain sensor – Audi A3
• Removing and installing alternator - vehicles with 1.9 ltr. TDI engine