Removing and installing right vent temperature sender G151 — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• The driver side dash panel trim must be removed on right-hand drive vehicles 68.
• To avoid possible interchange with other identical connectors, mark the connector (A) to the right vent temperature sender G151.
• On insertion, make sure the broad guide (D) at the right vent temperature sender G151(A) is opposite the mount (C) at the air conditioning unit.

📋 Procedure

1. Switch off the ignition.
2. Remove the glove compartment 68. [Note: The driver side dash panel trim must be removed on right-hand drive vehicles 68.]
3. Screw out the bolt (A) and detach the footwell vent air duct (B).
4. To avoid possible interchange with other identical connectors, mark the connector (A) to the right vent temperature sender G151.
5. Unplug the connector (A) at the right vent temperature sender G151(B).

6. Turn the right vent temperature sender G151(B) anti-clockwise (arrow) and pull it out of the air conditioning unit.
7. Replace the sealing ring (B) if damaged or defective.
8. On insertion, make sure the broad guide (D) at the right vent temperature sender G151(A) is opposite the mount (C) at the air conditioning unit.
9. Fit the footwell vent air duct .
10. Fit the glove compartment 68.
11. Interrogate the event recorder and erase any faults displayed.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures