Removing and installing right centre vent control motor V111 — AUDI

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016), Audi Q5 (8R, 2008–2017), Audi A5 Cabriolet (8F), Audi A4 B8 (8K, 2007–2015); platform code 83

• Special tools named: VAS 5051

Don't miss

• Mark connector (A) (to prevent interchange if several connectors are unplugged at the same time).
• The control motor has no stop; therefore the shaft of the control motor can be inserted in the cam plate (E) in any position.

📋 Procedure

1. Move front passenger's seat to rearmost position.
2. Switch off ignition.
3. Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box.
4. Remove bolts (A).
5. Remove air duct (B) to right dash panel vent (passenger's side).

6. Remove air intake box .
7. Mark connector (A) (to prevent interchange if several connectors are unplugged at the same time).
8. Unplug connector (A).
9. Remove bolts (B).
10. Detach shaft (D) of control motor (C) from cam plate (E).
11. Insert shaft (D) of control motor (C) in cam plate (E). [Note: The control motor has no stop; therefore the shaft of the control motor can be inserted in the cam plate (E) in any position.]
12. Fit bolts (B).
13. Plug in connector (A).
14. Route wiring harness so that it cannot come into contact with moving components (e.g. lever).
15. Re-install all other components removed in reverse order.
16. Switch on ignition.
17. Perform basic setting and final control diagnosis for air conditioner Vehicle diagnostic, testing and information system VAS 5051 ("Guided Fault Finding"). [Note: The control motors on this vehicle are equipped with an electronic feature which enables a new control motor to learn its position at the air conditioning unit during basic setting; only then can it be activated by the air conditioner operating and display unit (Climatronic control unit J255); currently all control motors are identical Vehicle diagnostic, testing and information system VAS 5051 ("Guided Fault Finding").While you are performing the basic setting, the control motors are assigned and adapted in accordance with the series connection of the wiring. If the sequence is not as specified, the control motors will not be adapted properly and the flaps will not be controlled correctly (overview of air conditioner control motors).]
18. Interrogate event memory of air conditioner operating and display unit (Climatronic control unit J255) and erase any faults displayed Vehicle diagnostic, testing and information system VAS 5051 ("Guided Fault Finding").

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing oil seals for propshaft flange, "“selectable all-wheel drive”", "“0C7”"
• Checking flow rate ahead of fuel filter
• Removing and installing ATF cooler, 6-cylinder petrol engine
• Removing bevel boxes as of model year 2010
• Replacing oil seal and grooved ball bearing for propshaft flange