Removing and installing reversing camera — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove rear lid trim General body repairs, interior70Rear door trims.
3. Release and disconnect connectors (arrows) of wiring harness leading to reversing camera.
4. Release and disconnect connector (arrow) from number plate light carrier.
5. Unscrew the 4 securing nuts (arrows) from number plate light carrier.

6. Remove number plate light carrier (1) and guide wires (arrow) out of rear lid.
7. Pull reversing camera in (direction of arrow) off number plate light carrier.
8. ⚠ Danger of leakage!Twisted or not properly positioned seals may result in danger of water ingress into the luggage compartment.Check that installed seals are in good condition and in proper installation position. — Connect and engage all connectors of the reversing camera wiring harness.
9. Secure wires and connectors with wiring retainers to prevent rattling.
10. After installation, clean reversing camera lens with a lint-free cloth.
11. Recalibrating reversing camera system .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures