Removing and installing retainer for rear DVD changer R162 — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Open left-side luggage compartment storage area.
4. Swivel rear DVD changer R162 into luggage compartment.
5. Unscrew bolt (1) (6 Nm) and nuts (2), (4) and (5) (6 Nm). — 6 Nm (4.4 lb-ft)
6. Swivel retainer into luggage compartment.
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Clutch "“B”"
• Clutch "“A”"
• Servicing 6-speed manual gearbox 0A3, four-wheel drive — Servicing gearbox cover
• Servicing 6-speed manual gearbox 0A3, four-wheel drive — Removing and installing differential
• Servicing 6-speed manual gearbox 0A2, front-wheel drive — Removing and installing differential