Removing and installing release mechanism: Audi A2
Step-by-step removing and installing release mechanism for the Audi A2: 22 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 21 Nm (15 lb-ft) | Tighten bolts (2) (2x) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove rear seat .
- Release rear seat backrest .
- Remove release handle trim .
- Remove release mechanism trim on both sides .
- Remove rear seat backrest cover and padding .
- Remove backrest section cover panel .
- Remove upper release handle .
- Mark position of bolts.
- Unscrew bolts (2) (2x).
- Unscrew bolt (3).
- Detach release mechanism (1).
- Screw in bolt (3).
- Screw in and hand-tighten bolts (2) (2x).
- Fit upper release handle .
- Fit backrest section cover panel .
- Fit release handle trim .
- By turning release mechanism (1), set release mechanism (1) such that release handle moves freely (tap with hammer).
- Install rear seat in vehicle.
- Align release mechanism with striker plate and backrest section.
- Tighten bolts (2) (2x) to 21 Nm. — 21 Nm (15 lb-ft)
- Fit rear seat backrest cover and padding .
- Fit release mechanism trim on both sides .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing starter, 2.0 l TFSI engine, vehicles as of model year 2010 with manual gearbox
- Removing and installing rear window wiper blades, vehicles without joint-free rear window wipers
- Removing and installing spray jet pop-up cylinders, vehicles as of 2010
- Removing and installing headlights, headlights with H7/H15 bulb, as of model year 2010
- Removing and installing ignition/starter switch, vehicles as of 09.2009
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.