Removing and installing relay and fuse carrier in luggage compartment electronics box (left) — AUDI
Removing and installing relay and fuse carrier in luggage compartment electronics box (left) on Audi: 6 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D4 (4H, 2010–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolts (2) and (5 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open the electronics box in the luggage compartment.
- Disconnect second battery A1.
- Detach relay (4).
- Unclip relay socket (1).
- Unscrew bolts (2) and (5) (2 Nm) and remove the relay and fuse carrier. — 2 Nm (1.5 lb-ft)
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing oil seals for flange shafts
- Removing and installing locking cable at shift mechanism with Tiptronic
- Removing and installing brake master cylinder together with brake servo unit
- Removing and installing reservoir with block connections
- Removing and installing lock carrier with ancillary components
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.