Removing and installing - rear seat backrest storage compartment, equipment version with long wheelbase — AUDI

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

📋 Procedure

1. ⚠ Observe safety precautions when working on pyrotechnic components .Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Remove seat frame/rear seat backrest .
2. Equipment version with Rear Seat Entertainment: Remove DVD changer R161Communication91DVD/CD changer; Removing and installing DVD changer.
3. Remove trim for storage compartment in rear seat backrest .
4. Remove rear shelf .
5. Unclip the cover (1) to the front using the removal wedge3409(arrow) and detach.

6. Remove trim panel with switch for compressor of refrigerator box .
7. Open lid (1) for refrigerator box.
8. Remove bolts (arrows).
9. Press insulating mat for back panel slightly to one side and unscrew nuts (2, 3, 4, 7, 8, 9).
10. Remove bolts (1, 5, 6 and 10).
11. Disengage the rear seat backrest storage compartment to the front from the studs and detach.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling drive shaft with 89 mm or 94 mm dia. outer constant velocity joint
• Checking fuel pressure and residual pressure, vehicles with 2.0 ltr. TFSI engine up to model year 2012
• Checking fuel delivery rate - vehicles with 3.2 ltr. FSI engine
• Exploded view - sump (bottom section) and oil pump · 2 torque figures
• Removing and installing timing chain cover (top right) - vehicles with engine codes CGQB, CVUB, CVUC, DEHA