Removing and installing rear door trim, vehicles as of 2013 — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Renewed: if necessary

Don't miss

• Take care with the metal clips in the area of the interior door operating mechanism. They grip very firmly and must be released very carefully.
• Before installing, check fasteners for damage and renew if necessary.

📋 Procedure

1. Switch off ignition and all electrical consumers, and remove ignition key.
2. Remove window handle if there is one .
3. Using removal wedge3409, carefully disengage switch trim (3) in (direction of arrow a) from door trim (1).
4. Swing switch trim (3) in (direction of arrow b) out of door trim (1).
5. Release and disconnect connectors.

6. Using wedge T10383/1, unclip trim (2) from door trim (1).
7. Turn trim clip (4) below door trim (1) 90°, and pull it off.
8. Remove bolts (1).
9. Release door trim (1) from clip connections. Use wedges T10383 to do this. [Note: Take care with the metal clips in the area of the interior door operating mechanism. They grip very firmly and must be released very carefully.]
10. Pull door trim (1) upwards vertically out of window slot.
11. Depending on vehicle equipment, disconnect wiring harnesses and connectors from door trim. [Note: Before installing, check fasteners for damage and renew if necessary.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures