Removing and installing rear bonded rubber mounting — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• Mark installation location of bonded rubber bush for gearbox, e.g. using felt pen.
• Thrust piece T50008/4 must be pressed completely to cross member.

📋 Procedure

1. Remove rear final drive .
2. Unscrew bolts (1) and remove cross member (2).
3. Mark installation location of bonded rubber bush for gearbox, e.g. using felt pen.
4. Press bonded rubber bush out of cross member as shown in figure.
5. Press bonded rubber bush into cross member as shown in figure.

6. Thrust piece T50008/4 must be pressed completely to cross member.
7. Install cross member.
8. Screw on cross member »finger-tight« using bolts (1) .
9. Then align cross member centrally on bolt holes and tighten bolts (1) to specified torque.
10. Install final drive .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures